SR-48591 - Onshore power cables shall either be designed and tested in accordance with /1/ or be designed and tested in accordance with /2/ with the following addition:This document and its content is for authorized company use only.SR-48625 - Cables with minimum ambient design temperature below -15 deg C, shall have documented bend/impact test for this ambient temperature in accordance with annex E in /4/. Such cables shall be tested for cold bend/impact at -40 C/-35 C in accordance with annex E in /4/.Can Statements of possibility and capability, whether material, physical or causal.AC Alternating Current FAT Factory Acceptance Test FO Fibre Optical HCF Hydrocarbon Fire IEC International Electrotechnical Commission NCS Norwegian Continental Shelf NDT Non Destructive Testing NEK Norsk Elektroteknisk Komite PD Partial Discharge TDR Time Domain Reflectometry XLPE Cross-linked PolyethylenePart 1: Cables for rated voltages of 1 kV (Um = 1.2 kV) and 3 kV (Um = 3,6 kV) IEC 60502-2 2014Part 2: Cables for rated voltages of 6 kV (Um = 7.2 kV) and 30 kV (Um = 36 kV)Shall (requirement) Requirement strictly to be followed in order to conform to the document and from which no deviation is permitted, unless a deviation permit is approved. Should (recommendation) Indicates that among several possibilities one is recommended as particularly suitable, without mentioning or excluding others, or that a certain course of action is preferred but not necessarily required, or that (in the negative form) possibility or course of action is deprecated but not prohibited. May Indicates a course of action permissible within the limits of the document.Supplier Manufacturer or manufacturer's agent that supplies the equipment and is normally responsible for service support. Manufacturer Original manufacturer of the equipment. U Rated power frequency voltage between conductors for which the cable and accessories are designed U 0 Rated power frequency voltage between conductor and earth or metallic screen for which the cable and accessories are designed U m Maximum value of the “highest system voltage” for which the cable and accessories may be used